I meant to say “additional gasket”. I understand you are just using whatever coming with the Flux kit.
2 Likes
Yeah additional isn’t 100% necessary
2 Likes
New AT2 deck and enclosure on sale for Black Friday, what do you guys think? Trying to decide between this and the MBS Pro 97 DWII + eboosted for a bottom mounted carver. Price is only $100 more for the Flux after buying the same trucks, wheels, etc.
New enclosure is injection molded and can hold 18x 21700 cells in each of the 6 compartments for a 12s9p configuration or possibly a 18s6p if 6 sets of 18s1p batteries were made and paralleled. Extra room in the front for a small BMS like Flexi
Heat sink mounted & ready
Edit: or this for 18s6p
10 Likes
Personally I’d definitely do this over the mbs for a bottom mount carver.
4 Likes
Dude I’m so tempted 
3 Likes
8 Likes
Any suggestions for 20S5P?
1 Like
should work aswell, 4 comparments with 15cells (3 parallel groups) and 2 compartments with 20 cells (4 celgroups.
1 Like
Any idea if the mounting holes are compatible with trucks other than channels? I just got the bn 270 hangers and baseplates and would love to possibly use them on this platform. That discount is reeeealy tempting but I’m not gonna buy a whole new drivetrain for it.
2 Likes
They are traditional skateboard mounting holes
But 270s might not be wide enough you would also have to have adjustable baseplates to get it at the right angle
let me do some homework I think there’s a couple guys
Doing Lunas 350 rkp and one doing tkp
I’m getting the adjustable baseplates already so that shouldn’t be an issue. If you can find examples of someone already doing this successfully, then I’m probably gonna end up getting it. My current enclosure is very bad and it’s giving me nothing but trouble.
1 Like
MBS M2’s are 414mm with axles and they’re basically 1cm away from wheelbite with 190mm pneumies. Anything less likely will bite.
3 Likes
BN 270s are more like 380mm but with the adjustable BP it could work.
1 Like
With thanes it could work. The deck would essentially go over them.
Yes 
3 Likes
Long, thorough, in-depth review after 6 months of ownership by AS eSkater:
TL;DW:
Cons: weight
Pros: everything else 
10 Likes
Question about wiring the cnlinko lp16 2 pin connector. There are two pin labeled 1 and 2. Which one is positive and negative?
1 Like