What’ ackmaniac?
It’s a ‘copy’ of the VESC firmware with some other stuff, but it should work
i always set shit up as singles.
How do you set VESC ids so remote will work
Follow the wizards.
Hasn’t been working.
I just need to know how to get the VESC tool to recognize both vescs
Thank God I have the unity to replace this piece of shit flipsky
Just plug them in individually and do one by one
Set one up as master and one as slave
Do I live dual switch on
I have no idea what dual switch is
On VESC 6.6 there is a dual CAN switch
How do I set one as master and one as slave
Idk if it’s the ESC or VESC tool, but this shouldn’t be this hard. I was just trying to set this 6.6 dual as a backup for the unity I got or to use with another board, but VESC tool won’t even recognize both VESCs at the same time when I’m plugged into it like it should. So either fuck VESC tool or fuck Flipsky, or fuck em both.
Brother you don’t sound very experienced with vescs in general you should probably read some info before you kill a 300 dollar part
I always have better success with this.
First, make sure the can switch is on
( @abusfullofnuns showed a photo last time ), then as @glyphiks mentioned, plug into your master side, update firmware, SAVE, then plug into and update firmware slave side, SAVE, then go through detection separately.