For context on why I’m doing this because I don’t have the VESCS on hand as I lent them out
I modeled a real basic fake g300 for spacing
I want to Drill the holes for mounting and start working on designing the bottom support Bracket that I need to design. → tucker has already done so
As the bottom of the ESC will hang off, There isn’t enough length on the tail as it changes angle after a certain distance.
The only problem I have is the signal harness port I could not find dimensions on
and idk if the support bar in the middle of the tail is going to cause me issues in reference to colliding / straining at a aggressive angle from being to close.