think u mean negative offset
Are those the 125mm tires?
those are evolve tires, looks like the 175mm one
What is the dimension between the back of the rim and the back bearing?
What is the dimension between the back of the back bearing and front of the front bearing?
Alternatively what is the dimension between the back of the rim and the front of the front bearing?
I negative offset
Wait whaaaaat 125
I’m tempted to design a 3dp wheel just to try these
I wanna try a set on my meepo hub and see how much meat I have left after full inflate
They fit bergs(according to them) but Idk If anyone has tried them
Looks like they’re evolve branded so maybe they’d fit standard 3.75s?
Oh weird what
I didn’t know evolve had these tiny ones haha
I think the story is it’s a ditched prototype evolve had made
Those are evolve 175mm
What kind of tire sizes will fit on those?
From 165mm to 10 inch.
That’s a good amount of negative offset paired with that the pulleys have no carrier bearing.
Have you done any stress testing?
Are you worried about the wheel bearings or the pulley? I feel like most large wheel pulleys are like this
Just seems like all the shear stress is focused on the two wheel bearing at the end of the axle rather than spread across three points along the axle and the negative offset is only adding to the counter lever effect