I have extra 10T if you need. If you’re in the states.
1 Like
A little birdy told me that kaly gears are the same as etoxx gears… but i’ve never tried so don’t take my word for it.
4 Likes
This is a very juicy if true.
1 Like
I’m in Denver Co
If you want to PM me I’ll send them to you
1 Like
Maybe you can use these ones as a starting point:
2 Likes
Oh Boy! … that saves me a lot of 3D Work! you Sir are a fkin Legend! Many thanks
2 Likes
Not the holes i want i’m afraid. 9 inch wheels sit way too close to the case to put those on
1 Like
22mm, I don’t think they’ll work with your 20mm drives
1 Like
cheers man thanks a lot
hoped they were 20mm but seems not
You can potentially take 22mm one and do the grub screws right to have 1mm each on all sides.
Or measure your hanger and make sure it’s 20mm on all sides
2 Likes
SICCCK
4 Likes
I do but those holes are unfortunately not tapped. You’ll have to tap them yourself 
. Next batch will have tapped holes
2 Likes
Ah, fair…
Would be nice to have some holes similar to the grease port either on the side or inner facing
Btw, is the bashguard from batch 3 still a thing?
2 Likes
Yes. I can design something for batch 5
4 Likes
Did you order clamps?
I’ll measure tomorrow I think they’re 22 x 22
I might have some old-school trampa clamps Atc mounts
DM me if your interested 
5 Likes
I did :). I have gen one moon drives
2 Likes