im using Maytech open cans now
1 Like
Which one ? Interested of, full closed overheat too fast
1 Like
Do you take any precaution regarding water ingress when using open cans?
I cover my hall sensors with epoxy. If you don’t use sensors, no need to cover anything at all.
1 Like
Interesting, thanks.
You cover the little 3 effect sensors and the pcb? Would conformal coating also work?
I use MT 6365 closed cans but I am not heavy and I have a lightweight board. Great motor for me
1 Like
I agree, this one
1 Like
Definitely
2 Likes
I’m running 12s on 200kv aps 6384 motors @ 5:1 gearing cause I like speed.
Honestly less torquey than my 10s mtb on 190kv 6369 power plant motors @ 4.8:1 gearing.
I am blaming/suspicious of:
- the 9" wheels on the 12s mtb vs 8" on the 10s
- 10s battery drawing more low end current than 12s (maybe?)
- the 10 kv motor difference
- the 12s board being much heavier
Waiting on bolts and bearings so I can check fitments with
MBS Rockstar/Fivestar
Trampa Superstar/Megastar/Phatladz
Which also means you could run 9" tyres on your Lacroix
23 Likes
Did you buy a hypertruck or did someone send you one?
I was sent a hanger
1 Like
Can’t wait for some moon hypertruck gear drives!
4 Likes
Anodized purple? 
3 Likes
wheels are sexy
Oh boy…
I am very close to having my moon drives up and going. I just added the v-ring to one side and notice it added a lot of resistance to the wheel moving. Is this normal or do I need to do something to get the wheel to move more freely? Adjusting or adding grease to the v-ring? I already added some grease to the gears.
Thanks in advance,
I added a little grease around where the v ring touches. Grease will find its way there anyway but not immediately.
3 Likes
