The antispark switch was purchased before the redesign and posting the dimensions of the battery tomorrow forgot to measure it. From loose memory it’s 13"x6"x1.5"
I’m not sure how to figure that out. But I can tell you that I bought it like 8-10 months ago and have been topping it off every few months since then
I had @Chibatterysystems do it in the US. But realistically you can do it if you’re not chickenshit like me. Just cut the wrap, remove the plastic rectangle and foam. Pull the BMS and cut the BMS balance wires taking note of which is which and make sure none of them touch each other. Strip then extend said balance wires, add heat shrink and place the BMS at the end of the pack and reheatshrink the whole thing.
The 12+1? balance wires length prevents it from being a simple repositioning