Looking for one of these Kegel Adapters from BKB, it’s sold out so i don’t mind if it’s used.
Only need one.
Ignore I have the pulley, not the adaptor 
2 Likes
No worries haha, i have a 44T pulley with the Abec adapter, but need Kegel 
I have the Kegel adaptor pulley!
1 Like
I would think Jared would have them back in stock soon as they are part of his kits unless he has found a better pulley system
1 Like
He mentioned that he’s not gonna produce any more unfortunately.
Still lookin for the Kegel adapter!
He has to have something for his kits that he is going to use.
1 Like
Would this not be 3d printable?
Yes, but there’s no model of this available, and i wouldn’t trust a 3D print’s strength on the prongs to drive a wheel 
2 Likes
looks like my kegel adapters for the revel drives are 3d printed? I also saw @Lee_Wright print his own kegel adapters in one of his vids… that wheel looked pretty heavy!
2 Likes
Dual should be fine, but i’m going single, might stress it out a bit too close for comfort.
2 Likes
Yeah I run 3d printed kegel pulleys but they have bolts reinforcing them through a shim on the front of the wheel into the pulley itself.
1 Like