I just went the lazy route for sourcing my materials
1 Like
@Flasher @b264 it aināt mine lol, it came with the MTB I bought a while backā¦that thing has a plethora of issues
- loop key is backwards
- both enclosures were just held with weak Velcro
- hangars were backwards (matrix II)
- ESC wires were AWFUL
- sensors were in the UART port
- binding hardware was upside down (the screws)
- shock blocks were loose
- motor mounts were bent
- esc enclosure was a fucking a 10 cent plastic box
The list goes on
1 Like
Many unrecommended things can. Iād go for a nickel with tape
1 Like
Haha I penny pinch those parts if I can because I have bought $400 at least of battery and electrical supplies
1 Like
Is that board up for grabs? Iām still looking for a donation to start my second build 
1 Like
Haha hell nawā¦sheās getting some TLC on my bedroom floor as we speak
(New esc enclosure)
2 Likes
Iāve got a wife for that
2 Likes
lucky bastardā¦
Depends on the days
1 Like
Letās bring this back on topic:
Iām looking for the following:
MTB deck
2x 6374 or 6384 170kv (possibly with 4mm bullets)
Bindings
Sweet looking cable sleeves (all Iāve got is cheap and black)
Any suggestion of enclosure to fit a stormcore 60D and make it look good (it would be top mounted at the back)
Yea, Iāll pass on that then, thanks tho
Does anyone want the inverted loopkey harness and half a dozen shitty 3.5mm male to 5.5mm female bullet adapters? They look fine but the solder joints are a little lack luster
Been running like that since February 2019 
1 Like
USA-Looking for 1 Boardnamics 220 Hanger any condition just not bent thanks 
2 Likes
Pelican 1040.
1 Like
I ordered a pelican r20
Whose got a 6x2 tube?
bump
@dnack228 Do you have a soldering iron you can use?
1 Like
yes, I have a soldering iron and soldering supplies leftover from building an fpv drone
1 Like