What do you recommend to set the failsafe at?
Where ever they rest when you aren’t touching them. The center / idle position.
2 Likes
So I was setting up a vesc with my friend and he accidentally pressed the throttle while pairing the remote, and when i turned off the remote the motors started spinning full power (board wasn’t on the ground so we were lucky) maybe this happened to you too?
I road around for about 5 mins and turned the remote off before turning the board off, next thing I know the board rockets under my van into a curb. Smash
its funny how fast I can change my mind, working on a new deck.
gonna give this another try.
I can have a snowbike and cake to
3 Likes
Get a hoyt remote already
1 Like
Noooo
poopy thumb remotes
I have a massive thumb it doesn’t work for me
3 Likes
GT2B Mad Monkey mod… Boo Hoyt Puck…
Hahah. Well. Look at what a non poopy trigger remote did to your 5min old board 
Bamboo hoyt will outlast any of those plastic cases hands down 
1 Like
Ahh but 3x of those are still cheaper then a Hoyt puck 
1 Like
Not when you have to replace your deck
6 Likes
4 Likes
ouch
the wound is still healing, im in denial
5 Likes
Hoyt puke 
1 Like
Idk why everyone hates on the good ol nano v2. Its simple, cheap, never drops, you can literally use one remote with any number of boards so you don’t have to change remotes when you changes boards, and you can finger twirl it like a mother f*cka. Yes calibration I know I know
@NingNing good luck getting her back on he road
1 Like
for me.
calibration + feel. == dislike.
hammer head mod. feels good. constant calibration… == dislike.
2 Likes
I feel ya man the other positives out weight them for me is all.
2 Likes