On bright side, at least he used the cable sleve, only half of the way…
1 Like
get in here
11 Likes
No way man!
That’s lab calibrated aluminum-scrap-beam!!
Nothing shitty about it
5 Likes
4 Likes
4 Likes
the ESK VIII engraving adds a touch of class…
2 Likes
Laser cut
1 Like
5 Likes
I too solder at 90°C using a clothes iron with no flux.
11 Likes
It’s about the challenge, not the results.
2 Likes
TUBE SUPERIORITY that board is perfection
1 Like
I got excited for a second thinking I was looking at hot pink TB130s
3 Likes
I would kill a kitten for a set of those.
3 Likes
Did Bill post his nips again?
3 Likes
Sir that is genius not shitty I’m sorry
6 Likes
Good idea, but need some polishing. Sure it won’t save you from going in puddle @ 30mph, but it will save your pants from dirt being propelled upwards.
2 Likes