Why do the rear wheels look like theyβre made of paper mache
3 Likes
On bright side, at least he used the cable sleve, only half of the wayβ¦
1 Like
get in here
11 Likes
No way man!
Thatβs lab calibrated aluminum-scrap-beam!!
Nothing shitty about it
5 Likes
4 Likes
4 Likes
the ESK VIII engraving adds a touch of classβ¦
2 Likes
Laser cut
1 Like
5 Likes
I too solder at 90Β°C using a clothes iron with no flux.
11 Likes
Itβs about the challenge, not the results.
2 Likes
TUBE SUPERIORITY that board is perfection
1 Like
I got excited for a second thinking I was looking at hot pink TB130s
3 Likes
I would kill a kitten for a set of those.
3 Likes
Did Bill post his nips again?
3 Likes
Sir that is genius not shitty Iβm sorry
6 Likes