*SCAM ALERT* neoHUB Group Buy (Same as loaded motor but sensored)

[Static]

Probably going to need to sand that enamel off. I found a mini rotary wire brush to be the best.

Any ideas for stripping motor wire enamel to solder connections? Motors are basically useless now

Need some tips on how to strip the enamel coating (shown below) on the motor wires of a pair of Maytech 6880s I have. For some reason the long phase wires are fully coated making it very difficult to shorten them and resolder because nothing sticks-. Nothing really strips the enamel either- heat, acetone, sanding. I need a good solvent, any tips? [image] [image] [image]