Yup, but they need the cores too.
Oh I want those
How are the 6 shooters colored? Annodizeed? Looks nice!
Spray on powder coat, they could do with a matte coat as well but I wound up not getting back to that project.
1 surfrodz rkp hanger with pressfits installed, good condition, one broken screw part in one hole of the pressfits, everything else solid. $70
200mm
3d servisas pulleys kegal 40t, too lazy to snap a pic rn but they’re in super solid condition just used. $85
SOLD TO BATMAN
Hi, I got two of these
presumably waterproof BMSs, one with 15A, the other 45A. The smaller was never used, the bigger one time only but in the end I decided to buy a more expensive charger and do external balancing with all my boards since I don’t trust any BMS
I’ll sell them for 10€ (15A discharge) and 14€ (45A) plus shipping from Germany.
Are they 10 or 12s?
Small one says 10s on the cover.
Oh, yes, they’re 10s both.
I have a brand new deck that I could sell for cheap. For 35 + shipping just EU.
If anyone want I could get hold of same deck but without graphics.
EDIT:
measurements: 40" x 8.75" (with the widest part where feet go 9.75). Whhelbase 30.7"
what deck is this and what are the measurements?
It is a no name one from a company here in Spain. It is 40 inches. Maple, little bit flexy, but not much
and width?
Just measured it. 8.75" the middle part and the wider area where feet go 9.75"
How many layers of ply does that have?