try this shit:
It’s really, really good… note 0.4" size is the smallest a sensor JST will fit thru…
Max @Scepterr recommended it! thank him!
4 Likes
I take it that you have a DOG
1 Like
Yes…! Your r right bud…!
1 Like
This is the best one I’ve found so far for these
4 Likes
JB Weld, my man
The alternative to the 3D Printer, and it fits in a small drawer
2 Likes
Thanks Brian! Do you think the voltage reader I linked would work?
1 Like
The “5 in 1 battery meter” variant might but not the “200A” variant
I would try the one I linked or the one @mmaner linked though
2 Likes
Thanks man 
1 Like
I wire them up in parallel plus-to-plus-to-plus minus-to-minus-to-minus with 24AWG wire. Then I write “4A max” on the back of them with marker.
2 Likes
Thanks man! So you wire the plus of the charg port to the plus on the display to the plus on the battery port? (Same for the negatives)
Yes
1 Like
Thanks Brian Do you happen to have a thread for how you waterproof your personal boards? If not I think a ton of people would love a thread 
Folks around here recently just try to make a meme out of me, I’m not really trying very hard anymore. Making a thread would take hours of research and digging up photos just to have homeless robots shit all over me for trying to help anyone.
4 Likes
Welp, I’ll start a pm as I’m really interested on how you water resist your board
That’s even worse, as any time spent only helps one person.
5 Likes
Ahaha, alright man! Guess I’ll test out some new ideas
1 Like
… Oops x)
1 Like
Well to be fair, there is an upside too, as stray robots don’t stop by to shoot hate everywhere in a PM
1 Like
I love that deck so much
3 Likes