Anything is possible I guess.
Axle is really short and the swivel part goes into the wheel offset when turning so a regular hub motor would not work as is
Anything is possible I guess.
Axle is really short and the swivel part goes into the wheel offset when turning so a regular hub motor would not work as is
How wide do you want your belts?
Brian : Yea
It does to me, how did you know?!
This isnāt my first rodeo
I got the Blade for 100 bucks! Itās in mint condition, he threw in the battered Cricket for $20! Now i gotta figure out what to do with them
Cricket is perfect for my daughter but needs a fair bit of workā¦
The Blade is a lot flexier than I would have thoughtā¦
At least you can finally fit those uncut belts you got?
There ya go
Tb stock pivot cup and hole measurement
Adjustable plate measurement where same pivot cup fits really nice
Real nice piece of work! Almost the Bumblebee - maybe with horizontal stripes!
@CiscoV can you send me a photo of it assembled? Kingpin attached and bolted through. Does it still rock?
Iām not able to look at it myself until about 2-3 days but I had one of my guys check and when assembled thereās wasnāt an issue. Heās testing a few others to see if thereās an issue.
If you can PM me with a video. I can try and figure out whatās going on.
Just did.
As stated in the pm. Thatās the rear truck assembly and all 4 of my Tb plates have the same hole diameter
When pivot cup is brand new the problem is less noticeable. As miles pile up problem became easier to spot
Maybe stuff some shredded paraffin wax in there.
Haha. Good idea! But I think dexter is already looking for a solution
Kinda blows for him cuz there are a lot of these plates out in the while. Til then Iāll be rocking my ray hammocks
Only the three of you guys have had any issues. Iāll check and get back to you guys.
what are they doing to those holesā¦
Itās official. Just had my boy check them and he agrees that that hole could be smaller Iām sorry man
Probably these go together
I have a mellow drive. Might try it
Mememememe, do me please!
Iād throw some heat shrink with glue on em and go ride, just me though.