I belive its their own deck produced by a german deck manufacturer (forgot which one, should be on the proj.-x thread)
3 Likes
It’s just a prototype deck. We’ve build already a new one 
3 Likes
Electric 2wheelboard!
Fucking hard to ride… But after a few years of practice “a fun way to die”
4 Likes
I made it to meme status apparently. 
21 Likes
That was one of the best posts I have seen in a long time
10 Likes
out of all the documentation and research…I finally understand just by looking at this one picture…amazing.
8 Likes
Plug for DIY one that I made.
Just vac formed it this morning, in 3mm styrene for a female mould.
17 Likes
Just a heads up, regular fibreglass resin will dissolve styrene. Not sure about epoxy.
3 Likes
Cheers mate. Will find out 
3 Likes
Amps are pulled though ?
1 Like
@mynamesmatt this is what you wanna be using the ABS for mate 
Excellent work @rosco can’t wait to see the final product
2 Likes
i get that they are pushed by voltage…amps is how much is being pushed restricted by Ohms (resistance) now i get why cold solder joints are baaaad. i understand contact surface area in batteries when dealing with connections now… series connections and all. I’ve been doing tons of research on electricity. want to learn how to build batteries. I’ll start with a N.E.S.E build first then move on from there.
4 Likes
Their video review was horrible. Their major complaint was that you can’t brake on a full battery, not realizing that that’s true of every electric board on the market. Why don’t they get someone with experience to review the thing, I don’t know.
6 Likes
watcha mean? I’m making an enclosure out of abs
1 Like
Make a mold out of ABS and fibreglass the enclosure
2 Likes
It’s like a game of spot the difference my wife and I are dying right now.
I’m just gonna start off with the obvious one
ONE OF THEM CAN DRIVE
13 Likes
It’s a lot like when you buy a high speed 4 wheel 60km/h electric skateboard self balancing scooter high quality 6000 watt.
6 Likes