Selling it all @magharees ?
you can take the wheel off the side of remote, there should be a little screw in the centre of it. makes it less bulky
I was gonna make a mod for it eventually, until then it’s gonna get clipped to my board with a chip bag clip because I spend 25 minutes looking for the damn thing already
haha saaame, loop key is even worse though
No loop key at least, there is no enclosure and the battery has an XT90s so I just use that
Someone was selling a Dewalt planer for $75 by me and my wife said I didn’t need it😑
Wtf??? I paid almost $400 for mine. Just go buy the damn thing!
So much want, I wanna make a epoxy river night stand kinda thing, but I dont have a planner.
Just buy it, say its for someone, then say they didn’t want it anymore… problem solved…
I had said I was going to buy it and said if it is still available when we get back I’m getting it and I kept checking and it sold in about 2 hours. I have a 1930’s Stanley hand planer that I refurbed.
Get a old hand planer and you would be able to do that.
That’s the green hubs/drives that I’m keeping for a slot on the slowest production line known to esk8
Dareno gets silver hubs/black drives
Don’t lose the wheel or screw though. That wheel can come in handy in future ESCs / accessories… like to control lights and horns and stuff…
it’s safely tucked away…
It’s @anon54720240 creation. He came over to Check wheel bite for Psychotillers new trucks. I didn’t want to take mine off, so I helped mock up similar geometry. We later went to His shop. 240s with 3, maybe 4mm riser was good to go. 260s exists
Great looking build. What deck is that?
I have a few old hand planes that I’ve been restoring too! I haven’t finished them because I get super distracted by every other project I have going on!!!
I hope so. Sooner or later Wanted to finish the Thanos first but the vaccum forming is holding me down for the moment