Just trying to figure out some enclosure stuff.
I don’t think I’m going trampa tho after all.
What all do ya got?? I like musicssss
hmm basicly only what you see on the picture:
a hackintosh desktop running ableton,
in the rack on the left side:
motu 828 mk2 interface
tc electronic d2 delay,
tc electronic m2000 multieffects,
mackie cr1604 mixing console,
behringer model D synth
other than that a korg radias synth with keyboard
korg volca keys, fm & sample
arturia keystep,
isla instruments kordbot
ableton push (first version)
somewhere hidden i also got a teenage engineering po 20 (arcade)
…and a few months ago i gifted my neece a po 33 KO <- really can recommend this one , its awesome
2x yamaha hs80 monitors for somewhat linear playback response
thats about it i guess 
1 Like
I’ve been wanting to get some stuff from them one day. I’ll check out the po33!
I need some new monitors soon, had some krk a for a while and traded them…now I wish I had them back!
2 Likes
worth every cent, i promise ^^
its the smallest musical sketchbook you can get - basicly a mini mpc
3 Likes
What’s this for? Cutting the urethane wheel face?
That means less contact patch 
1 Like
This for wheels they sell to everyone. They cutting boosted wheel logo off. Is all reject wheel sell.
7 Likes
I see, thanks for clarifying! How much of the thickness was cut off?
2 Likes
I measure sample I getting.
@stan you know what lights front/rear are used on those trampas? I need a solution for lighting up the road on my trampa build.
The first trampa uses tactical flashlight mounted to the trucks, those are really powerful to light up roads in front of you if you are looking for that. The other one uses a led in the front mainly for it to be seen from others, it won’t light up the road at all.
1 Like
3d printed mounts for tactical flashlights? Or just modified mounts it came with?
Not too sure about that, but I’m sure you could find some 3d printed mount for your trucks. Most lights comes with a rounded mounted system, so you will just need a “circle” adapter on your trucks.
They didn’t explicitly state to remove the cells first. This lawsuit will make me rich! Oh honey…
2 Likes
2 Likes
Want more pictures of how you set this up.
The 2 holes on the back for power wires and the squared front ones for phases wires :
A bit tricky to pass them through
but once done it’s perfect!
Don’t look at the Rx and BT module out (I was getting bad Metr. reports and tried different setup ^^), this is just where you can try to see the power wires out :
Just tape them to go ride on snow
If I remember well, I think I have put 2 inserts in the deck to screw the box on it with a little riser between them to let some space for the heads of the screws that hold the V6 to the box. Hope to be clear enough … sorry I didn’t find any pics of that.
4 Likes
No thank you. That’s helpful.
I need a waterproof solution. It’s rain season here and I can’t let that stop me.
1 Like
Once you pass your wires, just add silicone around the holes/wires and you’re good to go with a watterproof case 
2 Likes
we are getting the same in Wisconsin…sucks!!
1 Like