No one makes a bull bar for these MBS trucks. Other wise I’d be so down. Maybe I will design one later down the road if nothing comes out
2 Likes
Working on it my man! Utilizes the brake holes and M8 hardware for extra beef.
Speaking of, @moon, do you have the profile of the matrix hangers? I’m very close to right and am tired of test printing blocks.
10 Likes
Kinda want a bull bar/carry handle but the back motors stick out too much to pull by the front and I don’t want to move them up.
1 Like
Bull bar up front, handle in the rear.
3 Likes
I had this issue on my first board and made sure to mount the motors higher on these trucks specifically because of that.
I felt so accomplished making a handle the first time around just to pick it up and scrape immediately 
1 Like
What a tease
3 Likes
No USB type C though REEEEEEEEEEE
8 Likes
Just add slime and be happy ever after? And is this the T2 tire? I know I want that if my mountainboard ever happens, and these wheels are a new Jens work?
Will it be an adapter adapter for 8$?
Yes please
1 Like
But you don’t necessarily need USB-C PD or other fancy features, just the connector itself. I see them going for 25 cents a piece on alibaba…
Micro-B can be pretty sketchy with connectivity, which is important when doing firmware updates.
7 Likes
What is the DFU jumper?
What mote is that, nice hands bruh, real nice.
Is that the @DerelictRobot braughtworst version of the lil chubby?
@rusins I’ll look into it and see what we can do.
@Blasto Device Firmware Upload haven’t tested it yet though.
2 Likes
did you land on a name yet? i recall a post somewhere and TorqBox had most votes
2 Likes
@rusins I’ll probably switch it to USB C. 
Price should be fine.
@wandagoner TORQUE ESC! lolol but no not exactly yet…
9 Likes
DextorquESC
ETC = Electric Torqueboard Controller
1 Like