That looks clean as fuck
2 Likes
Thanks, i plan to have a silicone gasket seal behind it that is snug round the cables and keeps everything watertight. Wondering how much it would cost to get some made in aluminium or stainless steel.
2 Likes
@longhairedboy could you add 2x like buttons? So we can like it twice if its so good as this one eheheheh
1 Like
I’m reposting it because I feel I should gets at least 50 likes for the hour it took my unskilled ass to make
6 Likes
Since you have access to noice tools, you could replace the axle for a stronger metal, maybe Titanium?
1 Like
Yea I might just do that. If not I figure some snippity snappity things are going to happen.
4 Likes
Anyone knows if Caliber axles are a whole solid axle? Wonder how am I gonna remove it haha
You’re talking about CensorUnity? 
3 Likes
More like it does a diyeboard truck on me and I face plant but yea, that too 
1 Like
I’ve got a guy:eyes:
nice job btw
1 Like
i got this exact same setup, gonna install it soon.
are you going to run idlers?
1 Like
Was thinking about it, not sure if the torque is noticable enough to buy different belts again tho lol
“Technically” your mounts are upside down. But I’ve seen a few people do this now and you should do you.
You’re wrong, but you’re still cool.
Wrong.
Wrong.
5 Likes
Apparently I like to be different I’m so OCD it’s probably gonna drive me nuts now.
1 Like
You’re OCD? Look again, I straightened the horizon 
7 Likes
2 Likes
That’s looking good
Sadly not yet managed to figure out the sketch path for the rerouting to use the outer holes, need to do some sketch homework with the pipe combine. Guessing that’s what is needed
Those are the MR60 connectors? nice place to put em
2 Likes