That could explain my situation. I turned on my board and nothing happened then approximately 20 seconds later not having turned on my remote it went flying down the street lol
Fill it with crazy/super glue
Is there a reason to not use a stronger ‘glue’? Epoxy?
Believe crazy glue gets the surface itself to bond rather than sitting on top and joining the materials like regular epoxy (ie epoxy may be stronger in big globs but for smooth surface to surface and urethane super glue will do a better job)
Cool, thanks!
What are you thinking of using them for?
Who the fuck is throwing all these razor blades in the road. Luckily mine were already falling apart and about ready for a replace anyways.
as a charge port. looking to grab a 10a charger and the old 2.1mm barrel wont handle it.
at lease that was a DD with full thanes, your board would’ve exploded if it was a Raptor 2.shit
Where is this cluster of urethane with giant sharp shit in them coming from? Was there an Eskate meet up near a scrap yard I missed?
Lol just wondering for future reference
I’m going skating near pillow factories and angel pube dumps after yesterday’s spill.
Edit: yes I’m drunk and I stayed home.
These are prototype…
They look awesome.
I had a much less impressive crash a while ago and bought every single pad to wear including sanitary ones.
Yep, who doesn’t like some deep dish wheels right?
Wondering what this does for bearing spacing / axle length / rim width. Also noticed that only the driven wheels have bolt holes.
Are you trying to start a dual remote argument?