Damn. That was some shit. Heal up and build back up soon 
1 Like
Mini remote failsafe setting is in here
On any board with any remote, make sure if you turn the remote off (or wrap it with aluminum foil) that the skate goes to neutral/coast and not acceleration or braking
Pending approval by master robot of course
2 Likes
(Like is for first part of message, not the second. Grrrr.)
1 Like
1 Like
Please remember there are really 2 fail-safes that need to be set. There is a failsafe on the receiver so that sets what it does if it looses comm with the transmitter (this is the one that probably gets used the most), and a failsafe set in the esc that determines what happens when it looses signal from the receiver (ex. If the plug were to fall out or the receiver is goes poof). Please please please everyone make sure BOTH of these failsafes are set properly!
4 Likes
That crash video was ceazy my dude. Glad your alright you were cooking when you hit the asphalt.
3 Likes
I saw some posts about the GT2b having a fixed fail safe on the receiver that is at 1.5 ms, so even if you set with the remote it will go to that after a while, or this fail safe happens when you turn the board on without having the remote on
Someone can confirm, as I safety I set my VESC by having the middle point at 1.5 ms and never had to worry about it
Wow, sorry about your board and glad everyone is alright. Iām looking for a 6p pack if you want to get rid of the 6p 30q thatās basically done. LMK if youāre interested.
That could explain my situation. I turned on my board and nothing happened then approximately 20 seconds later not having turned on my remote it went flying down the street lol 
1 Like
Fill it with crazy/super glue
1 Like
Is there a reason to not use a stronger āglueā? Epoxy?
Believe crazy glue gets the surface itself to bond rather than sitting on top and joining the materials like regular epoxy (ie epoxy may be stronger in big globs but for smooth surface to surface and urethane super glue will do a better job)
3 Likes
Cool, thanks!
What are you thinking of using them for?
1 Like
Who the fuck is throwing all these razor blades in the road. Luckily mine were already falling apart and about ready for a replace anyways.
2 Likes
as a charge port. looking to grab a 10a charger and the old 2.1mm barrel wont handle it.
1 Like
at lease that was a DD with full thanes, your board wouldāve exploded if it was a Raptor 2.shit
3 Likes
Where is this cluster of urethane with giant sharp shit in them coming from? Was there an Eskate meet up near a scrap yard I missed?
5 Likes
Lol just wondering for future reference
1 Like