Arch boards 5055? Those look sweet.
You should electrify the wood on the right and call it : tandem esk8
Yep they’re Arc Boards 5055 motors. I believe their motors were made by Maytech, so pretty good stuff.
What wheels?
Fill that shit with super glue and pray lol
That looks so cool! Congrats. Will there be a build thread? I’m particularly interested in how you plug the motor wires into the enclosure. Looks like MT60 for the phase wires. Did you just use JST for the sensor wires?
This is how Roman does his makeup while his board charges
It was a process of elimination. Like, I knew for a fact you weren’t admiring your chicken legs.
What motors and mounts you gonna run?
Was thinking of 5055s and modifying profile to fit calibers. Playing about with @Boardnamics mount at odd angle and I can see with some filing it should fit and give reasonable clearance
Thanks! Won’t be a build thread, but motor wires us MR-60 connectors. Extended the sensor wires loom and plug straight into the board. Tempted to remove the MR-60 part and just do the normal inline connector inside the enclosure.
@pookybear. Whays that primitive looking thing on the left with white wheels? Those wheels seem a little small and i dont see a battery anywhere
Take the cans off and paint them black. Then lightly sand the cans until the paint and anodising is all gone on the top flat edge. Silver black stripy goodness. Don’t stare at them for too long though while they are spinning. Trips you out a bit.
Just for bench testing purposes =)
If it works it works lol
How you like them clones?