Reply to "Pictures and nothing else" thread

Yeah, I was literally crying from laughing under my visor.
You should have seen him walking like a penguin trying to cut me off. Fucking hilarious. Unfortunately the camera was pointed at me so I did not get that part.

If he had hit me though it wouldn’t have been so funny.

13 Likes

Dam! Crazy world !! :smile:

1 Like

Well, where I am right now on holidays is a small village.
That guy probably grew up using mules and oxes to commute and plow his fields.
He is probably telling his relatives right now about an alien invasion :rofl:

6 Likes

The guy at home now “you have to believe me! I saw this alien with a blue helmet. I said: I don’t care from where you are but if you fuck with me I will fuck you first :joy: Then I gave “it” a lesson”
Amazing world😁

7 Likes

Send adress in pm and I reply with shipping cost this weekend

What ratio did you go with?

Maybe to you.

1 Like

He went with a 12T pinion

2 Likes

So you make metal wheel gears now?

@Mikenopolis LoL this is why I think all wheels could just be the color of brake pad dust – the same color as the dust that gets on your wheel cores. Then they’d look new all the time :slight_smile:

3 Likes

Honestly I wish every wheel had a white option so that we could dye them the colors we wanted

3 Likes

Same as me than haha

You mean like @hummieee tires?

1 Like

Sorta, the cores of TB110s do a good job of blending.

1 Like

I went against my instincts and followed

3 Likes

Why are you drilling holes in your helmet…

4 Likes

Cause helmet is for cool not for safety duh

3 Likes

Clearly he just added the metal to make the helmet stronger

If you have a Pass, there are vents under your ear you can run a hose clamp through, does no structural damage, also gives a good handle

What @Flasher did isn’t that bad because the side of the neck is not a high impact zone, just make sure you don’t get cut or stabbed by the new hardware. The holes are small and if there’s a washer on either side it’s not awful

3 Likes

Actually, didn’t drill holes at all. I removed some decorative plastic covering some pass throughs for optional bluetooth. Then found flashlights that could fit the space and mounted them. Added washer to make sure I dont crack the plastic while tightening. Only problem I can see that this caused me is that I couldn’t choose the angle.

3 Likes