You should always fuse the charge port also in the esk8
https://www.mouser.com/ProductDetail/576-099707.5WXN
These solder great and are very small
You should always fuse the charge port also in the esk8
https://www.mouser.com/ProductDetail/576-099707.5WXN
These solder great and are very small
Ya beat me to it. Btw @b264 if we have a fuse inside our chargers, should we still fuse the wire on charge port? Or is this just adding redundancy?
That fuse is on the input side of the charger.
Ouch! While riding or accident? When hangers split like that makes me freak out
I hope you are fine.
Fortunately this isnโt my board but someone elses.
Snapped Hex XL
I guess too long hanger, too thin cross section and wrong Alu. Or 200kg man
Yup I think all 3 play a factor
200kg. Typical American!!
Looks like it snapped at the screw hole
or
?
It did, which dave said that he worried about but cant do alot to try and fix because of surf rodz patents.
He said he has dude heavier riding it and thet have no problems though.
ah ok I was joking about it but it was actually true. Good to know.
Brah 250kg?
I think is a mistake. At that weight or you are 3m or you can not move and ride a skate.
Thatโs what i was thinking lmao. I would pay to see the esk8 that can move some one that weighs that much lol.
Im still waking up, cant think straight. I ment pounds not kg
ah ok then is not that much. I am about 85-87kg now with back pack. There are a lot of 100kg dude. The design has to change a bit for such long axle. Is it like 240mm right?
240mm right, I have a set that Im hopping dont meet the same fate.