I will absolutely test them as door handles and beer openers.
Marvel: Bear Walker Industries Partners with Marvel on Limited-Edition Skateboard Collection.
Just breathe Kai
2 Likes
Yes theyāre currently booked to hell with specific Collab lines. Canāt even get on a wait list for a custom at the moment. The last set of @venom121212/carnage131313(lol) ones where super dope.
@Mikenopolis youāre in socal right? Pretty sure California law is that electric skateboards are allowed anywhere that bikes are. Unless there are some other additional laws that Iām unaware of, which is like 100% possible
3 Likes
It is. Those signs have been there for as long as I can remember, Iāve been riding these trails for almost 20 years.
Cops, cyclist, pedestrians, Karens etc are not educated so they go by those signs. Personally only had one cop incident in the past 6 years with PEVs, the trail runs right past a police station and I was pull aside and educated the nice cop.
I was really just pulled in by Jesus walking. Then it was that 10mph thing. Which means ALL cyclist are guilty if they want to go by those ārulesā
4 Likes
5 Likes
If those voltages are even accurate. Sometimes those are ārecommended maximum operating voltageā and sometimes they are ācomponent rated voltageā and, in general, trusting specifications from folks profiting from a sale is unfortunately often a folly.
How strong are these? Ok for a street build with a 100kg alien on top?
Iām in love with them.
3 Likes
Yo even offroad with 100kg i see no problem. Massive Trucks
3 Likes
Ah, these are different form the first ones i saw. What about those in this picture? 
7 Likes
Legs looking like youāre trying to hold in a pee lmao
3 Likes
What do you charge for these?
So @Ricco, if Iām getting this right, the bullets were compressed too much and not making proper contact thus causing the abs fault?
2 Likes
Waitā¦if the sun is behind him then how is his face being lit. 
9 Likes
In my experience they work themselves loose over time. Constant vibrations are concentrated at the fixed point. This has happened to nearly every panel mounted board iāve done.
If you can make it so the wires have absolutely no room to vibrate/flex/move coming up to the panel mount, you would likely negate this from happening.
I hate panel mounts 
3 Likes
Iāve experienced more reliability from panel mounts personally. But I also do clamp the wires to the deck about ~4cm after the connector. So maybe that is a big factor? IDK.
4 Likes
1.575 inches
6 Likes
We have a new FUB bot!
For the 5% of people for whom this matters. 
(395337529/7948875387)
2 Likes