FTFY
What’s going on here, what project is this?
Del-Rims
I’m using larger dia axles and bearings, so I needed to make my own hubs. Made some out of aluminum in the past but my machining wasn’t the best. So made these out of Delrin. I think they machined better but now I think I need to machine custom spacers and speed washers… they roll well but not perfect so still some stuff to figure out. Made them for the Hoyt St 7” tires.
Delrin is POM
Ever think it might be your choice in protective gear that results in your constant bleeding? I feel like a full face helmet or even helmet with a chin bar would be a better esk8 decision.
If you’re not bleeding, you weren’t having enough fun.
Full face helmets inhibit the flow of beer, and before you say it, drinking beer through a straw is not an option.
Not sure how much beer you’re getting through that respirator mask. But I’m with you on the beer through a straw
It can be done with a hot dog. It’s a glizzy.
The problem isn’t so much the current flow, but rather that beer through any straw goes all bubbly for some reason
It’s because of the lower pressure needed at the top end in order to convince the beer to flow upwards. The lower pressure also coaxes out the delicious dissolved gases.
This might have enough space to shove a can into your face. Just need to tilt your head once inserted.
This is why beer hats work but camelbaks don’t
So what you’re really saying is we need a beer full face…
Definitely saw the fabric on the right first and thought it was a tire
Bus-tin wheels??
Are those tubeless pneummies?