Add crayons for multi colored filament extrusions
1 Like
Congrats on graduating my friend! Big ups to you <3
1 Like
🖼 Pictures and Nothing Else! - #11980 by Arzamenable I laughed for a solid 1.76 minute about this… thanks you crazy doctor…
2 Likes
done that in a different room, its way more pain than gain 
perks of living in an a appartment building
2 Likes
I love it! This was my first board I ever built on.
Did you get those gear drives from moon like that or diy it? Let’s see some close ups!
Are you using the ats12 trucks?
How is that being produced?
1 Like
They are anodised
You can do some cool effects with anodising. Just look up yoyo anodising
3 Likes
Yup that’s them! They are beauty’s!
Boardnamics 270 and adjustable base plates
1 Like
Good choice 
1 Like
What are you doing here dude? Looks fun!
1 Like
he is sucking
5 Likes
Using a cheaper “vacuuming” way with some clothing vacuum bags.
Not as effective as a Vacuum pump, but if you “suck pump” every 10 minutes or so it will do the job.(better than hand laying)
2 Likes
Looking hella fine.
2 Likes
Yeah! Except the screws aren’t long enough for geardrive
Did you like the dual color print haha I think it looks really nice
1 Like
Yeah looks awesome! I wish I had a dual extruder.
The screws are designed to work with hex extenders for pulleys, but I think getting longer screws is a minor issue.
2 Likes
Ok, I love the idea of it, and I love goofy and complexes DIY solutions alltogether,
But this looks like so many potential failure points put together, I’m not sure I’d feel confortable ridding it
Is your Rim 3d printed?