Thank you!
Need a photo
Also wheelbase is truck bolt center (rear truck, front bolt) to truck bolt (front truck, rear bolt) center, not axle to axle.
Wheelbase is usually measured axle center to axle center. What do you mean by truck bolt? The king pin? The bolts that hold the baseplate on? Or the axle āboltā?
2 Likes
ā¦on cars
The bolt that secures the truck baseplate to the deck
1 Like
On everything except skateboards apparently. 
According to the website you posted the wheelbase is 48.5cm. Heres a picture from the side, very slim.
1 Like
Iām dealing with 38cm wheelbase.
Single stack just isnāt possible
Well my enclosure could barely work with your deck, I have 3cm to the front truck and 6cm to the back truck in deck real estate left. If you make a small nick (2.5mm) in the sealing flange you could run the same setup as I am. 
So SS is possible. 
That is, if you want to limit yourself to an 8s4p like I did.
1 Like
I prefer 50 to 100 cells 
Good to know though
1 Like
I hope you havenāt eaten all the gummy bears at once!
2 Likes
Lol, I hate gummy bears. (Most sweets for that matter). This has been a long time coming
4 Likes
Enjoy.
Single best investment I made in the last 2 years.
4 Likes
Ya, what a stubborn dork Iāve been with this.
I already see longer belts and extrusions in the works.
Complaint #1: upon checkout, provide an option for either gummy bears or chicken wings.
8 Likes
Prusa has been a really good printer only issue ive had really was the bed temp wire getting pinched and getting mintemp error, something to pay special attention to when assemblingā¦ The Prusa xl looks intresting too, its so expensive though.
2 Likes
Omfg 
6 Likes
So thatās just the quickest laziest way I could put together an eskate to test prototype decksā¦
Or is it a potential crab raccoon attack?
5 Likes
Thanks man!
25ā¦
Knees feel like 40
Mind feels like 16
19 Likes
Nice, the prime of your life dude! My youngest daughter will be 19 tomorrowš¬
10 Likes