P42A I suppose? What are the dimensions of that pack, im also thinking about building 12s5p in the future.
1 Like
Yes P42A’s.
Dimensions are roughly 240x125x80mm
(with LLT 20A smart BMS on top)
I’ll update with more precise measurements when I get home from work ^^
1 Like
Nicee, and thanks. Would quickly help me figure out if I can use that layout in my current enclosure 
2 Likes
@Creavenger 235x120*80mm measured c:
This is the absolute minimum you can go with this kinda pack. Add a couple mm for fishpaper, balance leads and heatshrink to be save.
2 Likes
Thanks bro appreciate it 
2 Likes
May I recommend heat shrinking or electrical taping the plier tips to keep them from pinching the insulation too much?
3 Likes
I have electrical tape on the other plier tip, but it slips to much to hold 2 wires at once.
4 Likes
Cooooold! That joint looks cooooold!
1 Like
Dude I used my 60w big iron and it was barely enough. 
1 Like
World’s first triple digit price tag loop key 
Jokes aside, that looks awesome man, great work! You planning on producing these, or is this just a one-off?
4 Likes
In context, while two 10AWG wires are sucking heat out, it’s not the worst joint I’ve ever seen. Still looks pretty cold.
We could produce them easily. Not sure if the demand is there though?
3 Likes
they can be printed so easily…
1 Like
Looks really nice but the price would probably have to be too high.
If you made something like that that was an aluminum DaVega mount that also had a charge port and a dope loopkey like that, then a high price could be more justified IMHO
Picture a mount where you pulled part of it away as the key, and there was a charge port on it also, maybe XT30 or 5.5x2.1
3 Likes
Sorry, I’m against printing for what we are doing
2 Likes
I was just speaking for the demand
3 Likes
That is already in the works for my current build!!!
1 Like
What tires are you using?
1 Like
How much would they cost to be viable for you to make some?