3d printed insert not sure if it’s going to be on the production boards, working on my review now, lots of good stuff to share in a bit after my legs stop failing and the cold brew brings me back from my current productivity coma.
It’s been an absolute joy to ride but saving the juicy stuff till after I have had the full run with it.
Is running the cables like that not an issue when the board gets picked up on end? The cable exit part of our motors is a weak point.
Yeah I can see how that can be an issue. I’ll have to see how it goes!
Based
I had them like that for a bit on my mountain board and it ended up being a nuisance and I had to move them…
God dude.
I want that Hoyt board so badly
Yeah I’ll probably end up moving them. Just a pain in the ass getting back into the gear drive with all that grease there lmao.
Love the enclosure that’s clamped on instead of bolted on, those are probably easy to water resist.
Bolts go through holes, just like water does
Fun fact I have the same unit from those photos lol I think theres only two.pre production units, but it’s got a decent level of finish for a non production copy.
Looks nice af
This is not the end
Btw what cf deck is that?
You will get more information in Spring. Right now they’re being tested.
What sized motors are those?!? They look HUGE
6396
Ahh, okay From the picture I thought they are even longer, like 63105 or something even bigger