It’s just a piece of transparent acrylic I sanded translucent. The light is just an ordinary light–an iwonder skateboard light in this case. I got the idea from the exway wave and Boosted.
If I could find a clear tailbone that fits Powell-Peralta (8") then I could add SMT LEDs to it.
I feel like ABS or nylon would be a better choice than acrylic though. I’m not sure.
That’s awesome. Great idea!
I made one for my hammerhead hosoi out of pla and it’s been solid. It’s got better impact resistance than a lot of other filaments and they make a clearish filament.
Becomes less clear with more infill and a kick tail would be solid but at least it would distribute light maybe?
Disposable e-cigs should be banned in my opinion. Saving these from the trash, turns out they have decent batteries in them.
You could have fooled me, with those microscopic wires in there.
What gauge are those?
haha, it’s like 30ga? Maybe smaller 0.4mm diameter. Not surprisingly the failure rate of these devices is quite high just from my experience. Another reason why I think they should be banned.
Maybe not banned, but just put a large tax on them
Agreed… you see them littered everywhere along parking lots and malls here in Chicago
here’s one that shorted, they literally have no QC
The benefit of the small wires is they make great fuses lol
Just noticed that riding 6 km home with it flat destroyed the tire also
Ooo that sucks
You put those slotted inserts in backwards homes. Not too big of a deal with the epoxy but for future reference the tapered, deep slot inserts are self tapping and meant to cut the path with the tapered edge down:
At least now I will fix the right way
Oh well, a bit late now. I ended up using the good old sacrificial bolt anyway so the flathead screwdriver got 0 use. Thanks for the advice!
Those little lipos power one of my remotes. Take off one of the end caps. There is the typical nickel terminal underneath.
what even is that? What motor/truck/board etc?
Never saw something like this