It’s not a TB enclosure. It’s for a hummie deck I think.
1 Like
What diameter are the bullet plugs? I was dreaming about phase and sensor connector in a plug together…
Will you be selling those?
3 Likes
In this model, 4mm bullets and 0.8mm pins. I also plan to make a model with 5.5mm bullets.
Yep 
Me as well. I hope I can make dreams come true 
More info can be found here:
11 Likes
Hoist (heavy duty lift) cable, £8000 for 100m of it, or so they say. Build your model and get rich lol
1 Like
Have you checked your clearance on turns? TKP trucks turn more, making the board go lower than it would with RKP. The Eboosted enclosure on my Switchblade is physically touching the ground on turns with TKP trucks and Bergmeisters! 
(drop through though)
2 Likes
Good catch! I need to check. I’m top mounting and using hammocks so have a lot of clearance, at least an inch of clearance (guesstimating with my eyes). But yeah, I need to jump on top of deck and turn to verify.
I had more than 2 inches and it scraped 
1 Like
How wide is your enclosure? Same width as deck?
My enclosure is narrow, 6.25”, and not full width of deck. I would have to tilt more to touch ground versus if I had enclosure that is same width as deck.
As wide as can be with a cm on each side for bolts. I think width could make a big difference.
Got picture of your switchblade?
Had to part from my trucks for a while, so I can only share how the bottom looks, but you can look that up in anyone else’s switchblade build with Alan’s enclosure. Important thing is to test your one yourself.
the TI-82 was the reason I got interested in programming when I as a teenager, made a lot of weird RPG games back in the day.
@ace there were so many fun games back then. zshell was the shit!
4 Likes
That doesn’t seem like very much lean. Is that all the way over?
2 Likes
Calculator Porn
6 Likes
What device are we looking at here?
5 Likes
I’ve got 5 years to beat you… bring it on 
1 Like