I believe so
What motor mount are these?
1 Like
His stuff looks so nice
3 Likes
I cooked this model up today, I will be doing testing and revisions this week. I hope to be able to sell these soonish. Ill also be releasing the .stl’s once they are more refined.
7 Likes
When can I start sending you money
4 Likes
Yoo these are genius. I’ll take 4, or happily help guinea pig and print/test too!
2 Likes
3 Likes
Lemme see those gold filament prints!
1 Like
@Jujo
I’ll start by homing it good with the red pla. Still got alot of it. I was told that keeping pla out too long can make it brittle. Is this true?
I don’t wanna waste a perfectly good roll
Yep, they should be in sometime next week
2 Likes
they still got the same length right?
1 Like
The 8mm portion was increased some as per request.
4 Likes
YAY
now I can run enertion pulleys without buying new flanged bearings!
not sure why I would go with small abec wheels on trucks that wide but I want the option dammit!!
-oh your pulleys too
What type of mounting plate is that? Looks great!
d00d i love the look on 'thane… well done!!!
1/8” thick aluminum plate I had laser cut. The hex standoffs I got off McMaster-Carr. When I finish it’ll have a 1/4” thick HDPE sheet for bottom cover and 3D printed frame to close off the sides.
1 Like