If you have a heelstrap, is griptape still necessary?
2 Likes
4 Likes
Bad placement didn’t want to drill another hole in the enclosure so I extended it.
2 Likes
Will do
Let me just get back from work
1 Like
He didnt have heelstraps either! Would have been a disaster.
I still think you want grip tape either way. Your feet arent completely immobilized by the straps.
3 Likes
That enclosure liner looks great man. Really pops
2 Likes
Thanks 
I ran a little short but I have a white one that I might incorporate in The cutting begins for meter/ charge port/ switch
1 Like
what is this? i thought it was a g2tb mod at first… but it’s not?
5 Likes
It’s something else for sure. 
Stay tuned.
5 Likes
Consists of 4 cells, symmetric around the middle, these are the internal dimensions:
The width is 189mm
Length (end cells) 137mm
Length (mid cells) 139mm
Depth (end cells) from 12 to 24mm
Depth (mid cells) from 26 to 31mm
Depth measured in the middle, it’s slightly deeper towards the sides, see pic
Hope it helps,
Dani
2 Likes
hall sensors?
bearings??
oooh…
5 Likes
That’s a yes.
Double bearings. 
4 Likes
Sure does lol. Helps me know I dont need it lol. Not big enough. Thanks homie!
1 Like
Is it just me or you need some better knee pads?
2 Likes
Wow that’s bringing back memories😂 The meepo v1 was my first board.
2 Likes
Same here! I don’t remember it being so ugly tho lol
1 Like
even meepo v3 cost less than 390 nowadays 
1 Like
Yeah probably, these were quite cheap. They are comfy and low profile but not the best for hard falls indeed 
1 Like
When I got mine they were $250 plus $99 shipping.
2 Likes
damn, that’s a good deal
1 Like