No problem at all, more so if on thumb rolling forward is accelerate and rolling back is brake, while on trigger pulling back is accelerate and pushing forward is brake (so essentially the pot is rotating the same direction for the same result).
1 Like
If you switch from thumb to trigger (or trigger to thumb) control, and you get used to it over the course of a few minutes and are riding along and BAM
a car pulls out in front of you, don’t you accidentally hit the wrong control by instinct occasionally?
I know I do.
It’s why I stopped switching controls very much. When you’re using your brain, everything is fine, but when you have a sudden instantaneous instinctual response often it’s reversed, which exacerbates the problems happening at that moment. You see the car and brace for slow down right as you smash the brakes … but then the skate starts accelerating hard … and all in a fraction of a second.
2 Likes
You could technically invert the pot?
1 Like
Nope, maybe because on both thumb and trigger remotes I instinctively put force through both throttle fingers in said directions.
1 Like
Bruh, did the lanyard break? Are you ok?
1 Like
super stealthy…
3 Likes
Wow, that looks really nice
3 Likes
Thanks. Itll be nice when the matching wheels come out. I personally liked the ones that you suggested but it looks like he’s leaning towards the colored ones, which should still go with the color pattern on my deck.
3 Likes
I’m fine, just felt stupid. Hit throttle accidentally. Wasn’t wearing lanyard.
2 Likes
I also drilled holes with it😂
does it really helps ? how much range do you get ?
I think the Spark works only over wifi, so you don’t get the 7km stock range from the Mavic
1 Like
Why does it look twisted on that last pic?
1 Like
Because I was seeing if a set of short bushings would still fit with these adjustable baseplates, but it wouldn’t let the trucks get anywhere close to tightened. So it still had a slight lean from when I had been standing on it a few seconds earlier.
Edit: damnit as usual I replied to the post instead of user
3 Likes
NICE work
what’s this board look like?
2 Likes
Ya will see next week 
Have to do the veneer and thats hard.
3 Likes
Yo am I the only one who thought this was a porcupine
2 Likes
No, same here 
3 Likes
