Ordered w upgrade already done
Might do spherical in hanger
PERFECT fit
Dude.
DUDE.
Nah, could have easily gone 63102 on there
So THICC
Cheers, it’s the first time I’ve used fibre glass, so not bad for a first attempt
Oooohhhh Boy
Gimme gimme gimme
Did you run some strength analysis?
Sure, I’ll get it on my blog soon.
Still playing with the bending tooling though
Shame your guys’ mounts aren’t interchangeable.
@Mikaelj has short mounts for Surf Rodz TKP
@XTLA has long mounts for Surf Rodz RKP
I need long mounts for TKP
I have long tkp, as long as your flat to flat hex was 19mm
Actually i only make a very little quantity of tkp for my self, but if some really needed longer plate, i can share
Hmm, I haven’t ordered the hex hangers yet. How good is my chance of getting them to fit that size? 50/50 ?
Edit: read your thread, I can sand them down if it’s too thick. good news then
Easy fix, rubber heatshrink if it loose, sand it down if too tight.
I would not call surfrodz tkp for precision trucks, but at least they are price worthy.
Agree
where did the other part go???
I think it was stuck on a bolt on pulley it seems from the indents in the wheel.
Love waking up in the morning to some wood