@pixelsilva Where did you get them?
Now back to the bench to repair what you broke for the photo shoot.
Which module did you use to get the Remote Signal to activate the lights (relays) ?
Is there something that already exists or did you use something like a car remote ?
Cheers
@glyphiks
How did you get that cool looking flat red color is it just resin or did you add something thanks
Its just resin with pigment added. And multiple layers of fibreglass and clear resin on top.
This board is awesome, dood.
Yes, two actually, one LM2596HVS that can take the full voltage and another LM2596 that can do constant current to drive leds
Will give a try to some caps
Charge only, FlexiBMS ftw
I have the channel 1 one the GT2b connected to an Arduino Nano, and it reads the channel and controls the light, the DC/DC converter Iām using has an on off pin that can be used to turn it on or off without relays or additional transistors
Itās the PWM reading, it should be stable 1875 ms, but as soon there is current on the motor it goes all over the place, but should be easy to solve
563
1
980
1
1837
0
1048
1
91
1
317
1
400
1
448
1
333
1
1876
0
1882
0
1874
0
1875
0
1882
0
694
1
1875
0
794
1
1459
1
433
1
1004
1
1792
That would almost include, a knockoff gorilla pod, a pixel 2, a 50mm lens mount adapter and my spine, no reward without risk yolo.
I didnāt. I wish I could. Europe Iām afraid ($$). For now a dreamā¦ Ā£170 each (but they are one of the best build in the market @NoWind uses them)
WoW da price has raised totally ā¦ bought my last ones for 110ā¬ PCS
BTW its not the really same motor, Horizon hobbies DYMOND is discontinued
Yeah, I noticed. These are Multiplex.
Some context for
Have been using custom remote for a long time itās great can be idle for like 40hrs and I didnāt even optimize for power consumption but there was no clear indicator it was on from the outside so I just added this led so itās very clear and a secondary light in my hand which canāt hurt (also makes it look a bit less like a gun?)
itās a radio wave gun.
I need to see you hold this haha
Can see it in hand here I should probably just print the top cover out of something bright too, to avoid confusion
It works just like a gt2b except I grip the trigger with two fingers so can brake by pulling up with top finger or accelerate pulling down with both, uses a linear hall sensor now and magnet in the trigger to detect position (also I had a screw stuck to that magnet on the trigger I didnāt notice).
Could move this hole for the light down further too was just an after thought drilled the hole to see if arduino was on in there initially.
Could you detail your process a little bit here? Iām gonna have to go through this with ~140 cells so any help is appreciated.
Did you have any cells that arrived below 2.9v? Were you able to recover any?
Any idea now on delivery times for the hellcat wides?
These were Surfrodz with old psychotiller mounts.
Since changed to some newer prototype trucks.