🖼 Reply to “Pictures and nothing else” thread_2020_summer

[bwahl602]

Its not your standard bustin deck. 6mm of maple was added first, then 6.5mm taken out and 10.5mm in the deepest part in the back

Elite Sportster - Unity | TKP | 12S4P P42A | eboosted | 110s

With glue up of the lower veneers complete, I had more material that I could safely remove to make room for components. In total, I added approximately 6mm to the deck and only about 3-4mm to the tongue and drop down areas. After the addition of those layers (4 in total with one partial fiberglass) the deck was very stiff, even without the enclosure on it. It wasn’t completely stiff, but quite solid. I expected this, and that’s why the pocket is large to give back most of that flex. Cutting the…