🖼 Reply to “Pictures and nothing else” thread_2020_summer

Media
#14618

Y’all burning alive at those temps. It just hit 8 degrees here and I’m in shorts and a t-shirt

2 Likes
#14619

Just curious what bms are you using?

#14620

Are those SSS motors any good for a mountain board with high torque at 12s and a stormcore or would you say predominately high speed? Seems all options are high KV sensorless.

1 Like
#14621

Not really any experience with them. These are my first, and I have not test riden yet

2 Likes
#14622

Part it out :star_struck::cut_of_meat:

1 Like
#14623

Now that’s some straight, uncut, fresh Unobtainium :tm: right there.

4 Likes
#14624

Haha. I’m not giving up on it just yet. Need to swap out the motors as the TB ones tried to kill me and then i’ll put some more kms on it.

I made some changes to the bushings which made a big difference to the ride feel, but I need to spend some more time on it before I make up my mind

#14625

One day those reachers will make it

1 Like
#14626

Yeah, not easily found, but they are kicking around here and there.
One thing to note, rayne changed the press and cut so much. I have a 2010 Northshore graphic and a 2013 bear graphic, neither fit Al’s mold.
Could have been made to work with gasket fuckery, but the panda fits like a glove.

1 Like
#14627

We just got word. Reacher fucked up and didn’t respond to some customs bullshit so the motors got sent back to them :man_facepalming:

But good news is they are coming express now this time

1 Like
#14628

Let’s see what skatan has for my budget :joy:

#14629

I need to take a moment to defend my skimpy D-seal gasket :blush: On a flexible, fitted enclosure a little D-seal goes a long way. I ride through slush and slop all of the time and the water has stayed outside of my enclosure, where it belongs. I also use rubber-backed, sealing washers to keep moisture from infiltrating the bolt holes. :sunglasses:

IMG_2519
IMG_25194032×2558 2.27 MB

IMG_2051
IMG_20511920×1527 425 KB

10 Likes
#14630

I was wondering why the bolt holes were inside the seal :smile:

Nice.

1 Like
#14631

Have you tried butyl tape?

1 Like
#14632

I’m open to ideas. Ultimately, I’d like to do custom gaskets for them.

1 Like
#14633

Man, Rocinante is faaast.

8 Likes
#14634

@jack.luis do you know how many amps you pulled?

2 Likes
#14635

I don’t :confused:

I should have pulled 95 motor amps per side, and at most 90 battery amps total combined according to my settings.

This drag race happened at less than 50% battery

But we all know it’s hard to actually hit your limits

#14636

As was the triple red shell he tossed in front of Ed.

2 Likes
#14637

@glyphiks that battery build is so clean. What enclosure is that?

1 Like