thatās some good looking wood
2 Likes
Itās sooooo close to done. I need to touch up a couple spots where not enough red frit locked in. Which means I need to also apply a bit more black graphite mica, too, or it wonāt match. Then one coat of epoxy on the bottom, and ceramic, and itās ready to build. Well, if I get lucky and one of my enclosures fits xD
And then I just have idk 14 more to do?
what are you planning for enclosure mounting on it? I wouldnāt want to damage that beautiful deck top with holes straight through.
I left the existing shitty through holes on it for now so that I can mount boosted gear and get it back on the streets asap 
but, with the aggressiveness of the concave, inserts are basically off the table, so Iāll probably use minimal bolts, epoxied straight through the deck, and re-frit over the bolts. When the time comes.
1 Like
Oh, and I think itās relevant that I will be using rubber AND metal washers on top while it runs boosted shit. I donāt wanna mess up this finish, after all.
1 Like
happenedI tried to run a single motor 2WD with only one mount. 
8 Likes
Can we get a picture of the ābeforeā Iām having a difficult time picturing this lmao
2 Likes
Which one is that?
1 Like
Sorry, no pictures were taken 
imagine a motor with a through-shaft, which is turning both wheels. Iāll be doing something similar in the near future.
Same exact one from as this one but without the flipsky branding.
1 Like
Ah thatās what I thought
1 Like
i heard good things about it so iām giving it a shot.
Iām using it to make 2S and 3S packs for the drones i built. 
4 Likes
Nice! I have yet to fall into that pit of obsession but I will one day
5 Likes
My son tells me he wants a racing drone and i think i went over board and built 13. My new addiction. I still ride tho.
5 Likes
Looking good! What trike frame is that may I ask?
2 Likes
Why is it not symmetrical!?
So you could ask about it.
9 Likes
Iām very curious, it do be pretty though