These are never going to fit on Caliber2 hangers, you need to buy a Boardnamics 184mm hanger which have longer axles and is a drop-in replacement.
Or, you can do this old trick:
…but I recommend the @Boardnamics hangers
These are never going to fit on Caliber2 hangers, you need to buy a Boardnamics 184mm hanger which have longer axles and is a drop-in replacement.
Or, you can do this old trick:
…but I recommend the @Boardnamics hangers
Awesome video, that’s much easier than trying to grind up the pulley lol
If you need any further help from me, let me know, and I’ll assist you if needed.
Are they compatible with Evolves Dkps?
Awesome! Now try this
Lol yeah please dont do that
Now, put a 608 bearing in the pulley.
I hate to say this, but with the condition of that mount, coupled with that hanger, it might be hard to get the motor pulley running true to the wheel pulley.
Damn, these are nice. Makes me want a thane board with belts.
Agreed. I have a 608 in the pulley now that I’ve cut the caliber to fit, but getting the motor mount parallel to wheel pulley will take some careful alignment. For now I’ll align it like @b264 suggested. I’ll upgrade the hanger and mount eventually, but for now this is a big improvement from my PETG pulley.
Is that a surface plate you have there?
I wish, just an old office table
I wanna know as well.
Me too.
Did you sand down the edge of the wheel?
I bought these used from nullbox. He did that
Anyone in the EU want some? Would be cool to split shipping cost