That’s genius. I might try that, at the moment I only ride down hills and I carry my board up and on flats.
4 Likes
Repost 
17 Likes
8 Likes
7 Likes
9 Likes
5News
11 Likes
Post your power/charge interfaces!
2 Likes
FatBoy X Plate Longboard Trucks Bracket with Charge port.
The plate was hard and it was difficult to make holes…
4 Likes
Hows it look underneath?
1 Like
The deck also has holes, charging cable goes to the enclosure.
1 Like
Charge port/Aux power in the rear
Headlight/tail light/ % display in the front
Loop key for power on the side
3 Likes
Really nice execution though really sleek
1 Like
Thank you!
I wanted to put the power switch here, but gave up because it was difficult to make a bigger hole. 
2 Likes
oooh i liiiike!
I wanted to do something like this on my haya 92. A lot like sofu’s build with a press fit 3D print on the inner mount holes to houseSwitch and charge port. I have to use the largest wheelbase because I’m using tb 110s and they have the slightest wheelbite with a 1/4 in riser pads.
2 Likes