new stormcore 100Dx, 18s6p battery just tried to do motor detection and got this error… kinda nervous so i just shut everything off. These FS 6384s worked before when I did detection on a 60D+
Not sure what to do…
I just updated vesc tool since I could even connect to the board without updating it. All i did was update the stormcore firmware then went to motor detection
Do a hand test on the motor.
What are your settings, including the absolute maximum current?
I didn’t even set any of those settings yet, was doing the inital detection
not sure what this is.
The motors 100% worked as tested on a 60D+ a few weeks ago.
What are your settings, including the absolute maximum current?
I’ve rewrote the motors with these settings before doing motor detection. I literally don’t now what else to do
Try using an older version of VESC like 5.2 and see what happens.
fixed it, motors werent fully screwed down
