Can you explain how you did that?
What, me? The quote?
Excatly how you did it. Pressed on reply and clicked on the speach bubble on the top left.
I assume you mean that? :
.
@Deodand, I noticed this menu the other day for the first time. Can you please give me a brief summary of what these values do and expected outcomes of changing them?
@Venom121212 i can tell you with what I understand from charles’ words that the transition is at what rpm sensors turn off. He told me to bring it up when full throttle from standstill was making my motors wizz without spinning
Thanks for the data bud, I appreciate it.
The Metal plate on the Motor is more of a heat thing or to “dust/rock Proof” it?
Can you explain how you did that?
It’s explained in here
The motor is pinned against slippage as per So it’s just a dust cover and it holds the pin inside the shaft and rotor.
Any idea why I stop going up a 10% hill? I start up the hill, slow down, and within 15 feet stop completely. I had thought it was voltage sag, but I am not seeing it in the data. I have a single drive 6374 with 36:16 gearing, 90mm ABEC, and a 10s3p 30q pack. Rider and board are about 180lbs.
Follow up from previous post. I re-calibrated the remote and that was definitely off, so the good news is I made it up the hill! The not so good news is my speed was ~3mph. Is this what I should expect, or is there something else I should look at? VESC settings as follows:
Motor_Min=-60.0
Battery_Max=45.0
Battery_Min=-16.0
Cutoff_Start=34.0
Cutoff_End=31.0
Temp_Start=85.0
Temp_End=100.0
Watt_Max=0
Speed_Limit=35.1
Wheelsize=90
Motor_Teeth=16
Wheel_Teeth=36
Motor_Poles=14
Battery_Cells=10
Battery_Wh=290
Does anyone know what this type of connector is? I am trying to extend the unity power cable without modifying it.
5 pin jst ph or zh.
Measure the pin to pin distance in mm and let me know the result
If it’s 2mm, it’s ph.
If it’s 1.5mm, it’s zh
hello
i am about to order 2 of the above, is my motor selectoin ok for these vescs
190kv, 6374 or higher? maby
thanks
- Pretty much any 190kv bldc motor should work.
- The only restriction is that you might have to remap the sensor cables.
@jonisingt35r
Should be jst ph then. I might have a few laying around. You in the US by chance?
What is Motor Max? What motor is it?
Yep. (MN)
Got you mane. Pm me your address and I’ll send you one. It’s 200mm long, that work?
200mm would work great! PM sent.
Noob question here. I have a 10s4p 30q. I’m currently running one motor but will soon be running two motors. When i upgrade to two motors, since my battery max amp output is 60a, does that mean each motor is only getting 30a?
Yes, you’ll need to lower “battery max” to 30A on each one. (same thing with battery min) You will still have more power available though. “motor max” is still higher, regardless of number of motors. (same with motor min)