Lol! thanks, and i’m fixing my post
For two motor is should be no problem for torque. Motor is very power.
1 Like
Polls can only be edited within the first 5 minutes.
1 Like
I make render for motor to show what look like.
1 Like
(old discontinued version)
https://www.daddiesboardshop.com/ronin-cast-longboard-trucks-180mm
(new narrower version)
These trucks have a “queen pin” that makes them very stable yet responsive. Excellent trucks, very desirable, but very few motor mounts fit these well.
There’s always trade-offs, right? The actual motor is very small, so it can make lots of power/torque but if so, must get very hot very quickly. So far every hub motor I have tried gets very very hot (Carvon, Enertion, Hummie, ownboard, torqueboard/maytech/madhubs). All that I’ve tried I believe are larger (much larger) than 5035.
Still, if they fit Ronin/Cronin and run well, I might have to get more than 1 set…
@jeffwuneo thanks for doing all these ideas for us!
5 Likes
For these motor I watch construction in factory. Is not like all other hub motor. Motor can getting warm, but is depending on how hard you riding for. This motor use radial magnet for good efficiency with tight winding. Is done by machine.
This dimension for inside back. If truck smaller than 24.6mm then it can fitting.
1 Like
I measured, Cronin is 23mm at widest point. Nice.
3 Likes
For PU we make to 85m, so have a little more cushion.
4 Likes
Review by @sofu (I believe she thought these are good, and she’s tried a lot of stuff)
@jeffwuneo these motors also make your deck much more interesting. 
(thanks @topcloud)
6 Likes
it’s worth getting some better PU than off the shelf room temp cure stuff. it deteriorates quickly with heat over 160f. maybe you can find something good.
2 Likes
We plan to sell together later.
2 Likes
We make in our own factory. Our chemist can making PU and has for 20 year.
11 Likes
I will try Jeff’s urethane and compare against loaded/otang urethane
9 Likes
@jeffwuneo is it possible to make your machined paris-like trucks an option? I understand this will allow the width do be narrow?
1 Like
No this only work for other hub type.
1 Like
Worth noting that I’m reviewing the updated version and writing a new review. Their loaded collab.
So far so good
24 Likes
