need help with electric skateboard remote pairing

I am trying to pair my remote to my VESCs, but I can’t get the remote to register any input on my laptop. I’m not sure what I am doing wrong, but if anyone may now anything please let me know.

VX2 Pro remote from M Boards,
A FSESC 4 50A Based on VESC4 from M Boards (but it is no longer listed on the website),
and a FSESC 4.12 50A Based on VESC4.12 from FLIPSKY.

For the connecters:

I have a Bluetooth Module 2.4G Wireless Based upon the nrf51_vesc project to connect the VESCs to my phone,
the Bluetooth module that came with the VX2 Pro remote,
and a CAN connector to link up the VESCs.

for pairing I have set up the FOC with and without the remote Bluetooth module. I have also tried the pairing with the VESCs with taking the receiver off through different steps of the process.

pairing pic

pairing pic #2

pairing pic #3

and for a full pairing video, if anyone knows anything please let me know

thank you if you have any advice, but thank you.

Send a pic of the small remote receiver board and how you have it connected currently.

Bet TX and RX need swapped.

you’re in the pwm wizard with a uart remote. If the remote is getting live telemetry, go through the NRF remote wizard. If there’s no live telemetry when you spin the wheel by hand, switch the RX/TX pins on the esc side JST