Well it’s been a while, but today I’ve finally managed to finish this thing, so lets start:
First I’ve drilled some canals for the motor phase wires, and other cables that needs to go beneath the enclosure.
I have decided to use CNLinko LP-16 Connector for charging, since previous solutions got warm at 9A, decision was made to put it next to the power button, since I hang my board on the wall and this was the most convenient location to make plugging charger easy once the board is hanging.
While we are at charging, since its 3P battery I had some worries about cells getting hot while charging, so I did some bench tests with battery completely covered, and all went good, temperature was about 35-36 Celsius, so I am more than happy.
Since I am going to run motor wires form the top of the deck next to the X Brackets, aesthetics had to be taken in mind, and generally I hate when things are not at least decently clean.
Internals are finisher, all locked down with 3M Dual Lock, and hot glue where needed.
Installed the gasket…
What I have learnt from previous builds, always put some markers (here, I have used a small amount of grey tape) next to the holes locations, so you can locate them in no time and predrill the gasket for the screws, so it wont be torn or twisted during first enclosure install.
Time for the enclosure.
It’s done 
And of course, some cheap night shots, showing the installed tail lights 
Thanks