I only installed the firmware that came on it so far. it’s blinking red non-stop and when I do the foc test it says it has a fault “sensor detection failed” (but the motor has no sensors) and won’t spin but when I go to “terminal” and then “print faults” it says “no faults registered since startup”
What can I do?
I turned off phase filtering before doing anything and the voltage settings aren’t too high
I have a couple flipsky75100 doing this.
Also u know if other 75100 escs can do higher voltage? I’m doing 87v
I have this:
MakerX Go-FOC HI100 75V 120A Base on VESC100250
And this:
